Please note that most of the software linked on this forum is likely to be safe to use. If you are unsure, feel free to ask in the relevant topics, or send a private message to an administrator or moderator. To help curb the problems of false positives, or in the event that you do find actual malware, you can contribute through the article linked here.
And for data sessions (EnhancedCD or the Playstation type), then I don't know whether cloning software is actually to put the data in precisely the same location on the CDr.I don't know if any existing software is so meticulous about it, but in theory one could burn a CD in raw mode with adjustments to account for the write offset. Getting an exact match would depend on the drive: not all of them support raw mode, and the ones that do support it might refuse to write unusual things like offset-corrected data.
And you still need an accurate read of the disc.
See attached screenshot
@amariamiyep thanks man I just showing your quoted and Markuza97 to @DVDdoug
On the other hand, for plain integer PCM it is impossible to go beyond 0dBFS. Since your quoted text of mine is not originated from a lossy codec discussion, I have to point this out in order to make it clear.
When opening another file and exiting that file though, playing the previously played track starts it from the start instead of where I last left off
Is there an easy method of letting each file remember where I last played it, so that each file has a resume point on exit
Not like a manual bookmark, but an automatic book mark, like saving the last played position on exit
Your post made me start tinkering with the SACD settings in the Tools tab and I actually got it working!
Mostly the DoP for Converter cannot be checked and
DSD 2PCM Mode can't handle (64fp) it has to be (32fp)
These are my settings that worked
Output mode: DSD+PCM, DoP for converter (unchecked)
PCM Volume: 0dB, LFE as-is
PCM Samplerate: 352800
DSD 2PCM Mode: Direct (32fp, 30Hk lowpass)
Preferable Area: Multichannel
DSD Processor: DSD Processor
in cui version 1.7.0-beta 1, the "use custom text" is never shown on the buttons.
only the normal text is displayed when you move the cursor over it. this was also the case in version 1.6.0.
furthermore, after switching to another layout, no text is displayed for any button. only after restarting fb.
please correct - thank you