Hello ,
I am getting errors in Burrrn using Windows 10 64 bit .
Using a non - compliant EAC cue file for flacs .
firstPlease try to use the 'generic-mmc-raw' driver. :Finished processing file #1.
Finished processing file #2.
Finished processing file #3.
Finished processing file #4.
Finished processing file #5.
Recommended Album Gain: -6.06 dB Scale: 0.4977
WaveGain Processing completed normally
Initializing SPTI ... OK!
SPTILOCK:1,0,0: TSSTcorp DVD+-RW TS-H653J Rev: D100
Starting write
Starting write at speed 32...
Turning BURN-Proof on
ERROR: Cannot set write parameters mode page.
Turning BURN-Proof on
ERROR: Cannot set write parameters mode page.
ERROR: Cannot setup write parameters for session-at-once mode.
ERROR: Please try to use the 'generic-mmc-raw' driver.
ERROR: Writing failed.
then Settings > Raw Driver _On_
gives another sense code / mode error :Initializing SPTI ... OK!
SPTILOCK:1,0,0: TSSTcorp DVD+-RW TS-H653J Rev: D100
Starting write
Starting write at speed 32...
Turning BURN-Proof on
Using 96 byte raw P-W sub-channel data mode for CD-TEXT.
Executing power calibration...
Power calibration successful.
Writing lead-in and gap...
Wrote 1 of 26 MB.
?: I/O error. : scsi sendcmd: retryable error
CDB: 2A 00 FF FF D3 B4 00 00 1A 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 71 00 02 00 00 00 00 0A 00 00 00 00 04 08
Sense Key: 0x2 Not Ready, deferred error, Segment 0
Sense Code: 0x04 Qual 0x08 (logical unit not ready, long write in progress) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 0.029s timeout 20s
ERROR: Write data failed.
ERROR: Writing failed.
finally turn OFF the Raw Driver
and burns without CD text :Initializing SPTI ... OK!
SPTILOCK:1,0,0: TSSTcorp DVD+-RW TS-H653J Rev: D100
Starting write
Starting write at speed 32...
Turning BURN-Proof on
Executing power calibration...
Power calibration successful.
Writing CD-TEXT lead-in...
Writing track 01 (mode AUDIO/AUDIO )...
Wrote 1 of 183 MB (Buffer 100%).
This is fairly consistanly reproducable . : (