How can I fix the spectrum slowdown when playing high resolution(over 24bit-96000hz) audio sources?

Calibration line "improvement": Use either linear or squared domain instead of logarithmic (dB) for calculating the calibration line based on average of all FFT bins, in-addition to a feature to use actual RMS (FIFO averaging done in squared domain) or linear averaging mode for calculating the RMS spectrum

BTW, here's the video of a mockup of new linear averaging (one of three averaging domains that I've wanted to see in the new version of @Crossover's awesome audio analyzer component) and the return of crest spectrum (that was removed in foo_enhanced_spectrum_analyzer 1.9.2.0) for the upcoming Enhanced Spectrum analyzer 2.0.0.0 update:
https://www.youtube.com/watch?v=BOcHKE7VMsk

Here's the spectral descriptor lines (horizontal = Hz, vertical = dB) could possibly look like in foo_enhanced_spectrum_analyzer:

Note that monitoring fields for these spectral descriptors (e.g. spectral centroid) are obviously going to be different from this image above and it would look more like ones from foo_loudness_peakmeter

• Spectral descriptors: This is where monitoring fields are could be introduced into Enhanced Spectrum analyzer component displaying spectral features as the song plays
• Spectrum visualization with average and crest spectrum: Re-introduction of the crest spectrum from older version of foo_enhanced_spectrum_analyzer but this time it updates at higher refresh rate and are highly-detailed and also, the averaging domain can now be selected to linear, squared, and logarithmic

The encoder doesn't allow anything that isn't 44.1KHz... I just would want to try another sample rates  .

Would the component, in you opinion, be better after removing all restrictions, including the shift key modifier?

After the last update, it is in disable state (only tag mapping or options that didn't update, the rest was updated just fine). After changing it to Write and Update it doesn't survive foobar2000 restart and return to disabled state.

I'm (very slowly) working on a wiki page to show some of the hidden settings in CUERipper (there are a couple of new ones in CUETools too). This is only a rough draft and not anywhere near ready. I'm still testing and need to add a few warnings. Temporary link

Hi,
Meaning:
The component is unable to open <profile>\configuration\foo_discogger.dll.db.

Posible solution:
Replace it with a fresh copy extracted from the distribution file (foo_discogger.fb2k-component).