Skip to main content ↑ ↓

Notice

Please note that most of the software linked on this forum is likely to be safe to use. If you are unsure, feel free to ask in the relevant topics, or send a private message to an administrator or moderator. To help curb the problems of false positives, or in the event that you do find actual malware, you can contribute through the article linked here.
Topic: New VST adapter for foobar2000 (Read 36613 times) previous topic - next topic
TF3RDL and 3 Guests are viewing this topic.

Re: New VST adapter for foobar2000

Reply #150 –
Exactly the same situation @misio
I'm using iZotope Insight2.
 

Re: New VST adapter for foobar2000

Reply #151 –
foobar2000 is an audio player, not a DAW. It's highly unlikely that the internal architecture optimized for fast and efficient audio playback will be broken and changed to make VST plugins able to update their UIs in realtime. The VST support was added for audio effect supports, not for eye candy.

Re: New VST adapter for foobar2000

Reply #152 –
Quote from: Case on
foobar2000 is an audio player, not a DAW. It's highly unlikely that the internal architecture optimized for fast and efficient audio playback will be broken and changed to make VST plugins able to update their UIs in realtime. The VST support was added for audio effect supports, not for eye candy.
Yeah (I think anyone should understand that foobar2000 is not a DAW even though you can use DSPs within converter), but there is "Visualize with VST" that allows you to visualize audio with VST audio analysis plugins with minimal latency (but obviously it would not change audio output at all), which I use with AnSpec analog-style spectrum analyzer VST

Re: New VST adapter for foobar2000

Reply #153 –
Quote from: ohtoulouz on
Quote from: musicreo on
Quote from: Peter on
Quote from: musicreo on
Does this VST dsp work with more than stereo?
Should work. Do you know any specific VSTs that fail?

I tested  two upmix VSTs and while the gui of the VSTs shows that they work only the left and right channel is in the output.

Hello,

Same here. No signal from rear, center and LFE channels of (at least one) 5.1 upmix VST with no error reported. Upmix VST was working fine with old VST component. (Foobar 1.6.16 and VST component 0.11.7). Thanks for your work BTW.

Cheers.


I gave it a try again but the problem is still the same.  With stereo input there is only stereo output.

Re: New VST adapter for foobar2000

Reply #156 –
@Peter
thank you so much for this component, it's great.
I used to run a software crossover using the RS-MET vst in foobar for my speakers.
Unfortunately, the Channel Mixer component is not available in 64 bit, which was ideal to swap and combine channels.
It seems that the code is not available for a recompile. Could a in/out channel matrix be easily implemented into the VST adapter? Or as a separate foobar component? I have no idea how much work it would be, but it would make DSP in foobar much more flexible/