Skip to main content

Notice

Please note that most of the software linked on this forum is likely to be safe to use. If you are unsure, feel free to ask in the relevant topics, or send a private message to an administrator or moderator. To help curb the problems of false positives, or in the event that you do find actual malware, you can contribute through the article linked here.
Topic: outlaw receiver 976 plus crown amp Q&A (Read 484 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

outlaw receiver 976 plus crown amp Q&A

i have 3 set of Crown XLi 800 for my fronts centers an surrounds all 98db sen. an a xls 1502 for my two 15in subs 92db sen. 
their all connected to my outlaw audio 976 receivers xlr outs they are rated at 4volt min to 9volt maximum

my question is on the crown amps  should i have the Selectable input voltage at .755V or 1.4V

Re: outlaw receiver 976 plus crown amp Q&A

Reply #1
Quote
my question is on the crown amps  should i have the Selectable input voltage at .755V or 1.4V
I'd say1.4V.   ...You'lll be able to use more of the volume control range.    With 9V out and 0.775V sensitivity you can't even use 10% of the volume-control range.   With 1.4V sensitivity you're still using less than 20% of the range.   And in most "home" situations you won't be anywhere near the limits of the Crown amplifiers.   ;)
 
Quote
they are rated at 4volt min to 9volt maximum
I don't know what "minimum" means...   With the volume turned-down or quiet program material you'll get less signal.    With the volume control turned all the way down you'll get (almost) zero volts.

Re: outlaw receiver 976 plus crown amp Q&A

Reply #2
thanks im going try that

 
SimplePortal 1.0.0 RC1 © 2008-2021