21
Notice
Please note that most of the software linked on this forum is likely to be safe to use. If you are unsure, feel free to ask in the relevant topics, or send a private message to an administrator or moderator. To help curb the problems of false positives, or in the event that you do find actual malware, you can contribute through the article linked here.
22
3rd Party Plugins - (fb2k) / Re: Dynamic Range plugin
Last post by Case -I added the extra info the official component displayed to the result dialog too (per-channel DR, RMS and peak).
And I did some improvements / fixes to the DR value calculation. Turns out the official component reverts to using highest peak when the second highest peak they tell you to use is too low. I saw this causing issues with short and very quiet test signals.
The result dialog also has the dark mode improvement marc2k3 mentioned.
23
Other Lossy Codecs / Re: TSAC: Very Low Bitrate Audio Compression
Last post by neoOpus -24
Lossless / Other Codecs / Re: libttaR (TTA rewrite part 2)
Last post by rdtsh -good news:
i've been working on a multi-threaded version. the encoder is already done in the 1.1-dev branch
bad news:
the tta wikipedia page was deleted
25
3rd Party Plugins - (fb2k) / Re: foo_skip: skip tracks that match a specified search query
Last post by Sergey77 -26
Speech Codecs / Re: No ACELP.KELVIN encoder!
Last post by MihaiPopa12346 -27
3rd Party Plugins - (fb2k) / Re: foo_skip: skip tracks that match a specified search query
Last post by elcosomalo -28
Support - (fb2k) / Re: Foobar seems to ignore LFE channel.
Last post by Case -The outputs marked "[exclusive]" send the signal to audio drivers without any alteration. If your hardware doesn't support the format you will get an error like you quoted.
The additional WASAPI component from Peter is old WASAPI exclusive mode component. You don't need it, it's for people using foobar2000 v1.5 or older.
Edit:Your output has always been stereo if Windows mixer says you have stereo speakers.
So I do get LFE with your wasapi component. But do I understand that it's outputted as stereo now? Or was that always the case?
29
General - (fb2k) / Re: Win Volume Integration
Last post by Case -30
Support - (fb2k) / Re: Foobar seems to ignore LFE channel.
Last post by mzso -My reply from yesterday was incomplete. I was certain foobar2000 loses LFE intentionally in some downmix but was confused yesterday as I tested the bundled "Downmix to stereo" DSP and it retained it. And I have 5.1 speaker setup - without DSPs there is no reason to lose the LFE channel as I have a speaker for it.It seems like most issues I run into is caused by Foobar trying to be smarter than it can be.
The default output will lose LFE if you have configured your speaker setup not to have .1 channel. For example if you have just stereo output or 4 channel surround setup.
XAudio2 output component uses OS channel mixer, it too intentionally removes LFE if you don't have that speaker.
WASAPI exclusive mode can play the LFE even if speakers are set into stereo mode if you actually have a speaker for it.
My 'WASAPI (shared)' component retains the LFE in its internal downmix.
In conclusion, if you have only stereo setup and you want to ensure LFE stays intact, use the downmix DSP.
Edit:
Downmixing in foobar would rather defeat the purpose of the surround virtualization that I have.
Edit:
So I do get LFE with your wasapi component. But do I understand that it's outputted as stereo now? Or was that always the case?