91
Other Lossy Codecs / Re: lossyWAV 1.4.2 Development (was 1.5.0)
Last post by Nick.C -This would be further complicated if adaptive noise shaping was in use (which it is by default) as the filters are channel specific.
FL = WavSource("FL.wav")
FR = WavSource("FR.Wav")
:
SR = WavSource("SR.Wav")
MergeChannels(FL, FR, ..., SR)
--chanmask=0x63f
the calculated bits to remove are then removed from each of the stereo channels in the WAV data.From each ...
Complete n00b question that I didn't find much answer to. I see no -m in the signature immediately above, at least.The -m, --midside parameter only works with stereo content and determines bits to remove through analysis of mid and side channel data, the calculated bits to remove are then removed from each of the stereo channels in the WAV data. This means that the bits to remove value is the same for each channel (which is not the case normally) so the overall bits to remove for the processed data will likely be lower.
Reducing bit depth not by zeroing out both stereo channels, but by averaging bits - so that they are zeroed in a side/difference channel; is that -m?
Which might not be exploited in a way that gives any bang for the buck really?