Skip to main content ↑ ↓

Notice

Please note that most of the software linked on this forum is likely to be safe to use. If you are unsure, feel free to ask in the relevant topics, or send a private message to an administrator or moderator. To help curb the problems of false positives, or in the event that you do find actual malware, you can contribute through the article linked here.
Topic: Did I install WASAPI Component properly (Read 829 times) previous topic - next topic
0 Members and 1 Guest are viewing this topic.

Did I install WASAPI Component properly

I followed the instructions, and it is listed in the "installed components" section, but in the past I had to select it from some output setting somewhere. I don't see that option anywhere.

I just want to make sure I have done everything I need to make it work.

Re: Did I install WASAPI Component properly

Reply #1 –
You don't need to install any WASAPI component at all. WASAPI shared is built in to v1.6.0+ and native support for exclusive mode was added in v1.6.7. So even if you're avoiding 2.0, you should have it anyway.

See the Preferences here for picking a device with exclusive mode...

https://hydrogenaud.io/index.php/topic,124105.msg1026553.html#msg1026553

Re: Did I install WASAPI Component properly

Reply #2 –
Quote from: marc2k3 on
You don't need to install any WASAPI component at all. WASAPI shared is built in to v1.6.0+ and native support for exclusive mode was added in v1.6.7. So even if you're avoiding 2.0, you should have it anyway.

See the Preferences here for picking a device with exclusive mode...

https://hydrogenaud.io/index.php/topic,124105.msg1026553.html#msg1026553

Thank you, I knew those settings were somewhere, I forgot about expanding the selections nested in playback.

Any thoughts on Push vs Event? I have an RME ADI2 DAC FS.
 

Re: Did I install WASAPI Component properly

Reply #3 –
Quote from: marc2k3 on
You don't need to install any WASAPI component at all. WASAPI shared is built in to v1.6.0+ and native support for exclusive mode was added in v1.6.7. So even if you're avoiding 2.0, you should have it anyway.

See the Preferences here for picking a device with exclusive mode...

https://hydrogenaud.io/index.php/topic,124105.msg1026553.html#msg1026553

I have found that WASAPI (or the default driver for my RME ADI2 DAC fs) doesn't dynamically change the sampling rate, but apparently ASIO does. Is ASIO also integrated into Foobar?